How To Size A V Belt. The diameters of the pulleys are given as 20cm, and 12 cm, respectively, and the distance between the pulley axles is 1.3 meters. K section= 0.140″ multiplied by the number of ribs.
Wrap 1/4 inch nylon rope around both pulleys. Please contact us for belt sizing if. This means you would measure the widest part of the belt (thick section) and then from the widest part to the narrowest part of the belt.
How To Measure A V Belt V Belts Are Wedge Shaped And Are Used To Drive Pulleys Which Have A Reciprocating V Shaped Grove.
Also, keep in mind belts do stretch and unfortunately there is no specific value for how much a belt can stretch. The result can also be determined by entering the measurements into an online calculator provided by baum hydraulics corp. The idea is that the belt is pulled into the.
Overlap 4 Inches Of The Nylon Rope.
Push the moveable jaw downward until the belt goes from loose to tight and check the reading, which is usually found in the lower right or left corner. This is important to know because it is key in the measurement of your belt. Please refer to the images below noting where the.
Banded Belts Are Commonly Used In Applications That Require High Power.
You can do this by using a cloth or a measuring tape. Lay the marked nylon rope on a flat surface. The rib count will be the number after the letter.
K Section= 0.140″ Multiplied By The Number Of Ribs.
You'll also need to measure the width and depth to determine which section v belt you have. Draw a line across the nylon rope with a black permanent marker. So you want to know the width of your belt first.
You Also Use A Thin String To Take This Measurement And Place It On A Steel Tape To Get The Correct Length.
Here at mds, we offer a, b,. We have different types of belts, type a, type b, with different measurements. Wrap 1/4 inch nylon rope around both pulleys.