How To Reset Furnace After Power Outage

Just Flip Each Switch At Your Circuit Breaker To “Off” To Start The Reset, Then After About A Minute, Flip Them Back To The “On” Position.your Hvac System And Thermostat Should Still Be Set To “Off” At This Point.

Turn on the circuit breaker at the circuit breaker panel. Your air conditioner’s internal circuitry needs some time to reset after you turn it back on. When the thermostat is off, an air conditioner won’t accept power from the electricity points.

Turn The Thermostat On, Choose The Heat Setting, And Choose Automatic Fan On.

In doing so, you prevent your hvac system from “kicking on” again once power is restored. After turning it back on, you’ll need to wait for 30 minutes to allow your ac’s internal components and circuits to reset. Inspect your circuit breaker and replace blown fuses if resetting the thermostat doesn’t work.

Otherwise, You Can Remove The Batteries And Place Them Back In The Compartment To Reset Your Thermostat If It Isn’t Hardwired.

First, set your thermostat to “off” so that your air conditioner doesn’t try to switch on until you’ve checked your breaker panel. Once the power is back, you must reset the circuit breaker located in your laundry room or basement. It’s usually a red or yellow button located inside the blower compartment near the motor.

Give It About Two Minutes, Fiddle With The Thermostat, And See If The Heat Comes Back On.

Allow a few seconds to ensure that everything is in working order. You want it about five degrees less than the current temperature of the room so it will start working when it is turned on again. Once it is ready to go, switch it to “on” or “cool.”.

After Power Outages Happen, You’ll Have To Turn The Thermostat To The Off Position.

Because the gas valve has shut, the gas cannot flow and ignite, meaning the heat will stop working. Reset button—the furnace can also trip its reset button when there is a power outage. Look closely at the breakers controlling the furnace and reset them as needed.